Where I can activate Protocol Message by updating ABBYY Datasets

Question

During updating a dataset in FlexiCapture 12, you may face the following warning:

Einige der Informationsmeldungen werden nicht angezeigt, da das Schreiben solcher Meldungen in das Protokoll in den Programmoptionen deaktiviert wurde.
Some of the informational messages are not displayed because the writing of such messages to the log has been disabled in the program options.

How to enable them?

Answer

It could be enabled using the following:

  1. Open your FlexiCapture project 
  2. Tools > Options
  3. Enable one of the following checkboxes that currently disabled:

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.

Recently viewed