Community

How Page count differs in Flexicapture 8.0 and 10.0 version

In Flexicapture 8.0 when we process images it just count first page only from which we capture data. We can see the balance under license manager. It just deducts one page only,even there are 50 annex pages.What in Flexicapture 10 it counts every single page including annex pages. Is there any workaround for that
so that it just count first page from which i capture data and all annex pages do not count?

Was this article helpful?

0 out of 0 found this helpful

Comments

4 comments

  • Avatar
    Sushi
    Amarjit,

    It might be best to contact your sales rep in your region. In each region it is different and license option could be different too. There is an option in the FC10 license to only count recognized pages only like in FC8. It might not be an option in your region with FC10.

    0
  • Avatar
    Amarjit Singh
    Thanks for your reply Sushi.

    May you please provide me info on this, so i can find this option and try to test i.e. only count recognized pages. I will contact the regional sales person also whether it is available in our region or not,

    Thanks a lot again for your support.
    0
  • Avatar
    Sushi


    Amarjit,

    Just ask them if they can enable "Count recognized pages only" in your license.
    0
  • Avatar
    Amarjit Singh
    Thanks Sushi,
    I have contacted my regional manager and got what i was after.It is available in our region and possible to update the license according to user requirement and control the page count.
    They have updated our license for "Count recoginsed pages only".
    0

Please sign in to leave a comment.