This is my issue.
if my document is setup like so: (page with data & header data), Blank Page, (page with data), (page with data), (page with data), other pages.
if I setup my batch type to remove blank page the document definition will be applied to all document and this is how I would like it to work as my FlexiLayout as a search constraint to look for header stuff on page 1 and then I use other search constraint to look for data on page 3 and 4.So after the removing of the blank page I have: (document definition), (document definition), (document definition), (document definition), ...
But if I don't specify to remove the blank page my setup will not work I end up with: (document definition), annex, annex, annex ....
It's as if because of the blank page it will not keep the initial document definition how can I make it retain the first definition detected with the blank page as the second page.
Thanks
Comments
2 comments
Hello
Thank you for reporting this issue. It is already known for FC11 and not yet resolved. If your workflow allows it, please set the blank pages to be removed during preprocessing and adapt your FlexiLayout to match when there is no blank 2nd page.
As a workaround, you may also split your FlexiLayout into two different ones (page1-2 and pages 3-5) and set in the FC Distributed Advanced workflow a custom stage that will combine two documents (page1-2) and (page3-5) together if they are encountered together in a Batch.
Sorry for inconveniences caused.
What I did is did 2 FlexiLayout and then in Flexicapture I put them in the same document definition. Works like a charm.
Thank you
Please sign in to leave a comment.