Community

How to handle multiple POs under 1 PDF?

When create in flexilayout studio v12, noticed that all the PO split perfectly but when I move into administrator station and perform testing, noticed that the output only reflect 1 PO data instead of all. Please assist. Thanks

Was this article helpful?

0 out of 0 found this helpful

Comments

2 comments

  • Avatar
    Viacheslav (Slava) Prodan

    Dear Shereen,

    I see that you have not received an answer to your question in the community, so I will create a request on your behalf.

    Best regards,

    Viacheslav

    0
  • Avatar
    Rahul Kapoor

    Hi Shereen,

    If you have the required footers defined in the FlexiLayout Studio then you need to go to the Project Properties in Project Setup station. Under Image Processing tab, you need to select Create Document "Automatic when Document Definition is applied"

    Regards,
    Rahul Kapoor

    0

Please sign in to leave a comment.