Hi,
I have a project in which it recognizes a header and
then a table of invoice sheets (this does not have lines
that define the table). Invoices can have several sheets,
which when the second sheet has no invoice lines there is
no case that a sheet, that shadow directly and only be left
with the first and only one that has invoice lines. Currently
there are no lines but as you can not define correctly a line
ends pick other characters from the invoice randomly and create
lines with bad information. Anything happen to you?
Regards.
Skip second page if you do not have data
この記事は役に立ちましたか？
0人中0人がこの記事が役に立ったと言っています
コメント
7件のコメント
Hello, Antal
Do we understand correctly, that you are using the FCI project?
Please send us screenshots demonstrating your issue.
Hi Ekaterina, Thanks for your answer.
I tried yo make a patch, when and invoice arrives the second sheet does not have a data that i have used flag. I have used the funtion: if kwLineas.IsNull then Dontfind(); so it does not look for data if there is no such flag, this way i get a sheet to omit ir but at the time of verification and export if it appear, it is not a big problem since i only export whet is necessary but for this 100% i would like them not to appear those leaves. Attached images.
Thanks you.
Hello Antal
Please send us your project and a few picture for it.
Hi Ekaterina,
My problem with Flexilayaout is that a batch with two pages is treated as two diferent batches instead of only one (you can see it at flexilayaout.jpg). I need the second page to be skipped if it doesn’t have invoice lines, because it appears in administratio station too, but not correctly recognaized and it generates a residue that isn’t exported (see admin.jpg). This doesn’t happen in other cases. You have attached Flexilayaout2 and Admin2.jpg, where you can see that’s correct. Here you have the projects also.
Thank you.
How could send you the project?
Hello,
I'd recommend you to treat your documents as 1-page invoices that possibly have annexes (2nd page with no data). To do that, please follow the next instruction:
Open your FlexiLayout document and strictly define the Header.
Delete the Footer element.
Open properties of the project and disable the “Allowing multi-pages’ documents” checkbox (you need a one-page document).
Import your layout to the FlexiCapture program and in the Document Definition properties go to the Assembly tab. Mark the “Enable annex pages” checkbox and set minimum and maximum values equals 0 and 1 respectively.
Do I correctly understand your requirement?
Hi Ekaterina.
The problem is that the second sheet of the document with the sheets of the table and other times not, but that there is the booth
of the table, in that case i like the sheet that has no lines but has lines if it recognizes it.
I`m going to try what you tell me.
This is the project: Project
Thanks.
サインインしてコメントを残してください。